BT_Wiki

Ceci est une ancienne révision du document !

====== Instructions for TourMaker HUD ====== Back to guidedtour page

Just wear the HUD.

• Click on Clear to clear any previous work if needed
• Go to your tour starting point
• Start to chat your commentary
• Move to the first tour point, not too far from starting point and check that starting point is visible from there.
• Click on add waypoint , it will beep to tell you that position and direction are saved when taking the tour, the vehicle will move to that position
• A second parameter is recorded: a point 20m ahead of you in the direction your looking at. That info will be used if you later set tilt or rot parameter to “cam”
• Continue typing your comments and move to steps of your tour every time you save another position by clicking the HUD add waypoint a red cone will rez always check that precedent red cone is visible from next step otherwise your tour may collide with objects in the way. Phantom objects like trees do not count.
• When arrived at the end of the tour and last position stored just click on “save”

the HUD will tell you a weblink to your tour on the web. open link, and copy-paste text to a notecard

I suggest you rename this notecard “english”. You can later copy it and translate it in other languages. Notecard name is only relevant when you put more than one notecard in your vehicle to give riders a choice of tours or languages. In that case, names must be short to appear in a menu.

You can now detach the HUD from yourself. Memory is not cleared and you can later wear it again to continue tour.

Just put the notecard into the vehicle (called Guide) Then put that Guide into the guided tour base

Other buttons on HUD :

• to change HUD settings
• Tilt to set how vehicle will tilt vertically during ride from that point on.
  • flat. stay horizontal point. point up-down to next point
  • point. point to next point
  • Cam. points depending recorded lookat point
• Rot to set how vehicle will turn horizontally during ride from that point on.
  • no rot. no rotation
  • point. point to next point
  • Cam. points depending recorded lookat point
• CamView inserts a command to fix riders camera at a point (to focus them on some detail)
  • Set your camera where you want and cick
  • instruction it generate is @<x,y,z>@<x,y,z>@ camera position ant camera target.
• CamFree inserts a command to free riders camera from a CamView
  • @free@@
• Del delete last command, comment or waypoint.
• Zlock All your waypoints after that will be at your actual altitude.
• Zforce 20 Same but at altitude 20m. Use that for boat tours. For another altitude use chat command Zforce nn.nn. Use chat command Zforce 42.5 to block altitude to 42.5 m
• Zunlock Unlocks altitude.
• Clear Clear the memory before starting a new tour.
• Save Gives you a weblink to copy all your tour and paste in a notecard for the vehicle. the HUD uses a web Database for this

Chat Commands you can say in local. They concern more HUD settings and won't be recorded in tour notecard.

• to insert special commands in your tour